3214NXT
The 3214NXT Demand Flow Network Controller is available to configure with all commercial Fleck® 2750, 2850, 2900, 3150, and 3900 Control Valves. This demand flow system can be programmed to bring multiple units to the service position and back to standby based on system demand flow. The 3214NXT Demand Flow Network Controller uses on-board communication capabilities to link multiple valves via standard CAT3, CAT5, or better communication cables.
- Network two to four valves
- Simple, on-site network programming
- Easy installation with plug-in wiring harness
- Shift key allows digit selecting in programming
- 2x16 character LCD backlit display (letter or digit codes not needed)
- Valve, piston, and cam type default storage
- User and master programming modes
- Diagnostic mode:
- Current flow rate
- Peak flow rate (can be reset)
- Totalizer (can be reset)
- Hours between last two regenerations
- House since last regeneration
- Volume remaining (adjustable)
- Valve addresses
- CAT3 networking cable kit
- Remote lock
- Programmable for Fleck® and generic meters
- Programmable auxiliary relay output:
- Dry contact relay (fused at 3 amps)
- Program entire regeneration or during any part of regeneration
- Chemical pump output (volume and time)
